Virtual machines do not power on after you complete the clone or deploy from template workflow.

When you clone a virtual machine or deploy a virtual machine from a template, you can select the Power on this virtual machine after creation check box on the Ready to Complete page. However, the virtual machine might not automatically power on upon creation.

The swap file size is not reserved when the virtual machine disks are created.

Reduce the size of the swap file that is required for the virtual machine. You can do this by increasing the virtual machine memory reservation.

a

In the vSphere Client inventory, right-click the virtual machine and select Edit Settings.

b

Select the Resources tab and click Memory.

c

Use the Reservation slider to increase the amount of memory allocated to the virtual machine.

d

Click OK.

Alternatively, you can increase the amount of space available for the swap file by moving other virtual machine disks off of the datastore that is being used for the swap file.

a

In the vSphere Client inventory, select the datastore and click the Virtual Machines tab.

b

For each virtual machine to move, right-click the virtual machine and select Migrate.

c

Select Change datastore.

d

Proceed through the Migrate Virtual Machine wizard.

You can also increase the amount of space available for the swap file by changing the swap file location to a datastore with adequate space.

a

In the vSphere Client inventory, select the host and click the Configuration tab.

b

Under Software, select Virtual Machine Swapfile Location.

c

Click Edit.

Note

If the host is part of a cluster that specifies that the virtual machine swap files are stored in the same directory as the virtual machine, you cannot click Edit. You must use the Cluster Settings dialog box to change the swap file location policy for the cluster.

d

Select a datastore from the list and click OK.