The universal distributed logical routers (UDLR) needs to establish a connection to Edge Services Gateway before BGP updates can be exchanged. Verify that the UDLR is successfully peering, and that BGP routing has been established.


Log in to the UDLR by using a Secure Shell (SSH) client.


Open an SSH connection to UDLR01, he UDLR whose peering and BGP configuration you want to verify.


Log in using the following credentials.



User name





Run the show ip bgp neighbors command to display information about the BGP and TCP connections to neighbors. 

The BGP State will display Established, UP if you have successfully peered with the Edge Service Gateway.


Run the show ip route command to verify that you are receiving routes using BGP, and that there are multiple routes to BGP learned networks.

You verify multiple routes to BGP learned networks by locating the same route using a different IP address. The IP addresses are listed after the word via in the right-side column of the routing table output. In the image below there are two different routes to the following BGP networks:,,, and  You can identify BGP networks by the letter B in the left-side column. Lines beginning with C (connected) have only a single route.