You can view which data transfer protocol is currently selected by looking at the UDT Status setting in the node Admin Web console. HTTP(S) is the default protocol and is used unless UDT has been selected in the node Admin Web console for both the source and destination nodes.

1

Go to the vCloud Connector node Admin Web console at https://vCCNodeIPaddress:5480.

2

Log in as admin.

The default password is vmware.

3

Click the Node tab, then click the General tab.

4

In the UDT section, view the UDT Status.

If UDT is enabled, UDT is being used as the data transfer protocol. If UDT is disabled, HTTP(S) is being used.

Note

UDT is used as the data transfer protocol only if it is enabled on both the source and destination nodes. If UDT is enabled in only one of the nodes, the default protocol, HTTP(s), is used.

5

Log out of the node Admin Web console.