By default, vCloud Connector uses the HTTP(S) protocol for data transfer. If you enabled UDT, disable it to use HTTP(S).

You should enable HTTP(S) on both the source and destination nodes. However, HTTP(S) will be used as the data transfer protocol even if UDT is enabled on one of the nodes.

1

Go to the vCloud Connector node Admin Web console at https://vCCNodeIPaddress:5480.

2

Log in as admin.

The default password is vmware.

3

Click the Node tab, then the General tab.

4

In the UDT section, view the UDT Status.

5

If the UDT status is Enabled, click Disable UDT.

When UDT is disabled, HTTP(S) is enabled.

6

If you want to enable data encryption for HTTPS transfer, seeData Encryption and Enabling Data Encryption for HTTP(S) Transfer Protocol.

7

Log out of the node Admin Web console.