You use the vCloud Connector Server Admin Web console to do basic configuration tasks, such as defining your time zone, specifying proxy servers, or setting log levels. What you need to do depends on your particular installation.

The vCloud Connector Server Admin Web console interface is divided into five tabs, with the first three tabs, System, Network, and Update, and part of the fourth, Server, being used for general configuration.

The vCloud Connector Server instance is running and you have the IP address for it that you wrote down when you installed it. You also have the information you gathered in Collect Necessary Information.

1

Go to the vCloud Connector Server Admin Web console at https://<vCC Server IP address>:5480.

2

If you receive a certificate warning, accept the certificate.

3

Log on to the Server Admin Web console as admin.

The default password is vmware. Check the Web console title to confirm that you are configuring the vCloud Connector Server.

4

Use the information you collected in Collect Necessary Information to complete general configuration.

5

When you have finished with general configuration, keep the Server Admin Web console page open to the Server tab in your browser.

The System tab provides general information on the vCloud Connector Server virtual appliance, allows you to configure time zones, and lets you shut down and reboot the appliance.

On the Network tab, you can view network related information about the appliance, switch between DHCP and static IP addresses, and set up proxy information.

The Update tab allows you to check the update status of your virtual appliance and to set your update policy.

The Server tab has two parts. One part allows you to change the Server administrator password, adjust log levels, and manage SSL certificates. The other part is used later, in the registration process.

The Nodes tab in the Server Admin Web Console lets you register vCloud Connector Nodes with your vCloud Connector Server, download Node log files, and register Stretch Deploy settings