NetQueue is enabled by default. To use NetQueue after it has been disabled, you must reenable it.

1

In the ESXi Shell on the host, use the following command:

esxcli system settings kernel set --setting="netNetqueueEnabled" --value="TRUE"
2

Use the esxcli module parameters set command to configure the NIC driver to use NetQueue.

For example, on a dual-port Emulex NIC run this ESXCLI commands to configure the driver with 8 receive queues.

esxcli system module parameters set -m tg3 -p force_netq=8,8
3

Reboot the host.