Auto Deploy can assign a host to a folder or cluster. When the host boots, Auto Deploy adds it to the specified location on the vCenter Server. Hosts assigned to a cluster inherit the cluster's host profile.

Install vSphere PowerCLI and all the prerequisite software.

Verify that the folder you select is in a data center or in a cluster. You cannot assign the host to a standalone top-level folder.

1

Run the Connect-VIServer vSphere PowerCLI cmdlet to connect to the vCenter Server system that Auto Deploy is registered with.

Connect-VIServer 192.XXX.X.XX

The cmdlet might return a server certificate warning. In a production environment, make sure no server certificate warnings appear. In a development environment, you can ignore the warning.

2

Define a rule in which hosts with certain attributes, for example a range of IP addresses, are assigned to a folder or a cluster.

New-DeployRule -Name testrule3 -Item "my folder"	-Pattern "vendor=Acme,Zven", "ipv4=192.XXX.1.10-192.XXX.1.20"

This example passes in the folder by name. You can instead pass in a folder, cluster, or data center object that you retrieve with the Get-Folder, Get-Cluster, or Get-Datacenter cmdlet.

3

Add the rule to the rule set.

Add-DeployRule testrule3

By default, the working rule set becomes the active rule set, and any changes to the rule set become active when you add a rule. If you use the NoActivate parameter, the working rule set does not become the active rule set.

Assign a host already provisioned with Auto Deploy to the new folder or cluster location by performing test and repair compliance operation. See Test and Repair Rule Compliance.

Power on unprovisioned hosts to add them to the specified vCenter Server location.