With the software-based iSCSI implementation, you can use standard NICs to connect your host to a remote iSCSI target on the IP network. The software iSCSI adapter that is built into ESXi facilitates this connection by communicating with the physical NICs through the network stack.

Before you can use the software iSCSI adapter, you must set up networking, activate the adapter, and configure parameters such as discovery addresses and CHAP.

Note

Designate a separate network adapter for iSCSI. Do not use iSCSI on 100Mbps or slower adapters.

The software iSCSI adapter configuration workflow includes these steps:

1

Activate the software iSCSI adapter.

See Activate the Software iSCSI Adapter in the vSphere Client.

2

Configure networking for iSCSI.

See Setting Up iSCSI Network.

Configuring the network involves creating a VMkernel interface for each physical network adapter that you use for iSCSI and associating all interfaces with the software iSCSI adapter.

3

(Optional) Enable Jumbo Frames.

See Using Jumbo Frames with iSCSI.

4

Configure discovery information.

See Configuring Discovery Addresses for iSCSI Adapters.

5

(Optional) Configure CHAP parameters.

See Configuring CHAP Parameters for iSCSI Adapters.